Loading the page
Loading the page
Choose your vehicle to see only the parts that fit
Choose your vehicle to see only the parts that fit
IHTEFAQ MOTORS LTD Inner track rod pair, steering rack ends, in Steering. Two identical inner track rods with tab lock washers and hex nuts, one for each end of the steering rack. Price £36.99 including VAT.
Part no. IM-ITR-PAIR
Inner track rods, also called rack ends, are the ball joints at each end of the steering rack. They carry the movement of the rack out to the outer track rod ends and the front wheels, so play in one shows as vague steering, a clunk when turning or a car that wanders.
This pair covers both ends of the rack with two identical rods. Each has a cast ball joint housing with a short thread that screws into the rack, a silver shaft with knurled sections, and a long thread at the outer end for the track rod end.
Fit depends on the vehicle. Contact us with your registration number before you order and we will confirm these rods suit your car.
2 × inner track rod: identical, one for each end of the steering rack, each with its ball joint housing, short thread for the rack and long thread for the track rod end.
2 × tab lock washer: sits between the end of the rack bar and the joint housing. Its tabs fold against the housing so the joint cannot unscrew.
2 × hex nut: screws onto the long outer thread and locks the outer track rod end in place once the toe is set.
Price £36.99
inc. VAT
In stock
Replace an inner track rod when its ball joint has play. With the front wheel off the ground, rock it by hand at the 9 and 3 o'clock positions: movement there points to the steering joints, and a hand on the rack gaiter while someone moves the wheel finds the inner one.
Signs on the road are a clunk when turning, vague or wandering steering and front tyres worn on one edge. Excess play in a steering ball joint is a reason for failure at the MOT test. A torn rack gaiter lets in water and grit that wear the inner joint, so check both gaiters at the same time.
Remove the outer track rod end, counting the turns as it unscrews, then the rack gaiter. Unscrew the old inner rod from the rack bar while holding the rack still.
Fit the new tab lock washer against the end of the rack bar, screw the inner rod in and tighten it to the torque given by the vehicle maker, then fold the washer tabs against the flats of the housing so the joint cannot unscrew.
Refit the gaiter, screw the hex nut onto the long thread, then the outer track rod end by the counted turns, and lock it with the nut. Have the wheel alignment checked and set straight after fitting. Steering parts are safety critical: if you are unsure, have them fitted by a garage.
| In the box | 2 inner track rods, 2 tab lock washers, 2 hex nuts |
|---|
Estimated delivery: Fri 20 to Mon 23 NovFri 20 to Mon 23 November
Standard delivery