How to replace front brake pads
By DEMO Shop, published
- Difficulty: intermediate
- Job time: about 1 hour 30 minutes
- 3 min read
Overview
Brake pads wear a little every time you stop, and faster with town driving or towing.
Replace them when the wear warning light comes on, when you hear a steady squeal or grinding as you brake, or when the friction material is close to the wear limit given by the pad maker. Pads are always replaced on both wheels of an axle at the same time.

You will need
- Trolley jack and two axle stands
- Wheel brace
- Socket set and Torx bits
- Torque wrench
- Piston wind-back tool or a G-clamp
- Wire brush
- Brake cleaner
- Brake grease
- Nitrile gloves
Never work under a car held up only by a jack: lower it onto axle stands on firm, level ground. Brake dust is harmful to breathe, so clean it off with brake cleaner instead of blowing it away. If the brake pedal does not feel firm after the job, do not drive the car.
Step by step
Step 1: Loosen the wheel nuts
Park on level ground, put the handbrake on and leave the car in gear. Loosen the front wheel nuts by half a turn while the wheels are still on the ground.
Step 2: Raise and support the car
Jack up the front of the car at the jacking points shown in the owner's handbook, lower it onto axle stands and take the wheel off.
Step 3: Remove the caliper
Undo the two caliper guide bolts and lift the caliper off the disc. Hang it from the suspension spring with a cable tie so its weight never pulls on the brake hose.
Step 4: Take out the old pads and check the disc
Remove the old pads and their clips. Measure the disc thickness: if it is below the minimum stamped on the disc, or the disc is scored or has a deep lip, replace both front discs too.
Step 5: Push the piston back
Take the cap off the brake fluid reservoir, then push the caliper piston fully back with the wind-back tool or a G-clamp. Watch the fluid level so it does not overflow.
Step 6: Fit the new pads
Clean the caliper carrier with the wire brush. Put a thin film of brake grease on the points where the pad backing plates touch the carrier, never on the friction material or the disc, then fit the new clips and pads.
Step 7: Refit the caliper and the wheel
Refit the caliper and tighten the guide bolts to the torque given in the workshop manual for your car. Refit the wheel, then repeat the job on the other side.
Step 8: Check the brakes before driving
Lower the car, tighten the wheel nuts to their torque and press the brake pedal several times until it feels firm. Check the fluid level, then bed the pads in with a few gentle stops at low speed.
